show fa-service show fa-service name Command Output Descriptions Field Description Service name The name of the FA service for which the information are displayed. Context The name of the context in which this service is configured. Bind Status of connectivity of this service with context and IP address. Max Subscribers The number of subscribers are allowed to configure in this service. Local IP Address IP address to which this service is bound and communicate with HA. Local IP Port The port number on which this service is to communicate with HA. Lifetime The maximum time that the FA session can exist before it becomes expired. Registration Timeout The maximum duration of inactivity for a session registration before it becomes expired. Advt Lifetime Lifetime for an advertisement message. Advt Interval Interval between two advertisement messages. Num Advt The total number of advertisement messages broadcasted. Advt Prefix Length Extn Indicates the setting of prefix extension length in advertisement message. Reverse Tunnel Status of reverse tunnel. GRE Encapsulation Status of Generic Routing Encapsulation (GRE). Optimize Tunnel Reassembly Status of tunnel reassembly optimization. Allow Priv Addr w/o Rev Tunnel Status of setting to allow private addresses without reverse tunnelling. Dynamic MIP Key Update Status of setting to update dynamic MIP key. Ignore Dynamic MIP Key Status of setting to ignore dynamic MIP keys. Remove MN-AAA/MN-FAC extns Status of setting to remove MN-AAA and/or MN-FA extensions from messages. Standalone FA service Show the standalone FA service status. If “Enabled” system performs as a standalone FA only. Proxy MIP Status of Proxy Mobile IP support. Proxy MIP Max Retransmissions Total number of retransmission for Proxy Mobile IP support. Proxy MIP Retrans Timeout Timeout duration in seconds between two of retransmissions for Proxy MIP support. Proxy MIP Renew Percent Time: Percentage of timeout duration. Once this much percent of timeout duration exhausted the Proxy MIP message will be retransmitted. For example, If retransmission timeout is set for 4 secs. and renew percent time is configured for 75%, the Proxy MIP messages will be retransmitted after 3 seconds. SPI(s) The configured Security Parameter Index (SPI) number between FA and HA. FAHA Remote Addr IP address of HA. Hash Algorithm: Hashing algorithm applicable for HA. SPI Num SPI number set for HA. Replay Protection: Type of reply protection enabled for reply messages. Timestamp Tolerance Total variation allowed in timestamp mismatch. HA Monitoring: Status of HA monitoring configuration. GRE Sequence Numbers Status of GRE sequence number setting in messages. GRE Sequence Mode Specifies the GRE sequence mode. GRE reorder Timeout Total timeout duration for GRE reorder. GRE Checksum Status of GRE Checksum setting in messages. GRE Checksum Verification Status of GRE Checksum verification setting. Registration Revocation Status of registration revocation setting. Reg-Revocation I Bit Status of I-bit setting for registration revocation. Reg-Revocation Max Retries Maximum number of retries allowed for registration revocation. Reg-Revocation Timeout Total duration allowed between two retries for registration revocation. Reg-Rev on InternalFailure Specifies whether registration revocation will be triggered on internal failure or not. Default Subscriber Name of the default subscriber. Max sessions Maximum number of subscriber sessions allowed. Max challenge len Length of challenge key for subscriber authentication. Challenge Window total number of windows opened for challenge. Service Status Status of this service. MN-AAA Auth Policy Specifies the lookup criteria for authentication policy between MN and AAA in RRP. Possible settings are: alwaysignore-after-handoffinit-reginit-reg-except-handoffrenew-and-dereg-noauthrenew-reg-noauth Optimize-Retries Status of setting for optimized retries when authentication policy is not received for MN and AAA. MN-HA Auth Policy Specifies the lookup criteria for authentication policy between MN and HA in RRP. AAA Distributed MIP Keys Override Specifies the setting for the FA service to override dynamic keys from AAA with static keys to support MIP registration with HAs which do not support dynamic keys. Newcall Policy Specify that new call policy enabled or disabled to handle new calls. Idle Timeout Mode Idle timeout mode allowed for this service. Ignore Stale Challenge Status of setting to ignore old/stale challenge messages. Limit Reg Lifetime Status of setting to limit registration lifetime. Dynamic HA Failover Status of setting to handle dynamic HA failovers. AAA HA override Status of setting to override HA settings if received from AAA. HA Failover Status of setting to handle HA failovers. Retrans Timeout Timeout duration between two retransmission of probe on HA failover. Retries Before Swtichover Total number of retries before switching to another HA. Maximum retries Total number of retries allowed. Load Balance Status of setting to handle HA performance issues or HAa failovers by load balancing. HA Monitoring Status of setting to monitor HA. Inactivity Timeout Timeout duration after which a probe message will be sent to HA. Monitor Reply Timeout Timeout duration to wait for reply from HA after which a probe message will be resent to HA. Maximum retries Total number of retries allowed.
